Coolmay C600S - Chapter 4 Drive System Wiring and Introduction; Servo System Wiring; Servo Drive Wiring; Wiring Introduction

Chapter 4 Drive System Wiring And Introduction
11
Chapter 4 Drive System Wiring And Introduction
4.1 Servo System Wiring
4.1.1 Servo Drive Wiring
Pic 4.1 Servo System Wiring
4.1.2 Wiring Introduction
Wiring Notes:
 The control cable length should be less than 3 meters and the encoder cable length 20
meters.
 Check that the power supply and wiring of L1,L2 are correct.
 Please do not connect to 380V power supply.
 The output terminals(U,V,W ) must be connected with the servo motor
connections(U,V,W ) correspondently, otherwise the servo motor will stop or over speed.