Chapter 1 Product Inspection And Installation
www.coolmay.com
Chapter 1 Product Inspection And Installation
1.1 Product Inspection
This product has made the complete function test before delivery, Please check below points
after unpacking. (for prevented the product to be abnormal owing to shipping process,
please make detail inspection as the following items after breaking the seal:)
●
（Inspect the types of servo driver and servo motor and ensure that are the same types in
the
order form.
）
The purchased product is identical with your desired.
●
P
lease do not power it on if there is any damage on the product
appearance.
●
Inspect the parts of servo driver and servo motor to see any loosen parts such as loosened
or
fallen off screw.
●
Rotate the servo motor shaft by hand and should be smooth rotation.
However, the servo
motor with holding brake is unable to rotate directly. If there is any
break down item or abnormal phenomenon mentioned above, please contact with the dealer
immediately.
If there is any discrepancy, please contact the purchasing agents.
To Next Page
Loading...
