Chapter 1 Product Inspection And Installation
www.coolmay.com
Grounding terminal. Connect with power supply and motor
grounding terminal for grounding treatment.
Bus voltage indicator. Used to indicate that the bus capacitance is
in a charged state. When the indicator light is on, the internal
capacitor of the servo unit may still have charge even if the main
circuit power is off. Therefore, do not touch the power terminal
when the light is on to avoid electric shock.
1.3 Product Installation
1.3.1 Servo Drive Installation
Installation direction
The normal mounting direction of the servo drive is vertical and upright..
Fixed installation
During installation, please tighten the 2pcs M4 fixing screws at the back of the servo drive.
Grounding
Be sure to ground the driver grounding terminal, otherwise there may be a risk of electric shock
or interference to produce wrong action.
Wiring requirement
When connecting the drive, please wire the cable down (refer to the below picture) to avoid any
liquid attached on the cable and then it flows into the drive along with the cable.
Installation interval
Refer to pic1.2 for the distance between drives and installation intervals with other devices,and
please note that the picture indicates the smallest size, in order to ensure the performance and life
of the drives, please leave the full installation interval as far as possible.
Cooling
The servo drive adopts natural cooling mode and forced heat dissipation mode.
Installation considerations
Prevent dust or iron chips from entering the servo drive when installing the electrical
controlling cabinet.
To Next Page
Loading...
