Copystar CS-2030 - Detaching and Refitting the DF Separation Pulley

3A7
1-4-3
(2) Detaching and refitting the DF separation pulley
Clean or replace the DF separation pulley as follows.
Procedure
1. Open the DF original cover.
2. Remove the screw securing the original feed
guide and then the guide.
3. Remove the stop ring, pull the separation shaft
out and remove the DF separation pulley.
4. Clean or replace the DF separation pulley.
5. Refit all the removed parts.
Stop ring
DF separation
pulley
Separation shaft
Figure 1-4-5
Original feed guide
Figure 1-4-4