1-3-1
3B1
Section
Item
Maintenance item contents
Initial
No. setting*
U600 Initializing all data —
U601 Initializing permanent data —
U602 Setting factory defaults —
U603 Setting the user registration data
• Setting the self telephone number —
• Setting the type of telephone line —
• Setting the number of rings in the fax/telephone auto select mode —
• Setting remote diagnostic transmission —
U604 Clearing data
• Clearing transmission history —
• Initializing the cipher key password —
• Initializing the F-code confidential box ID —
• Initializes the F-code relay box ID —
• Initializes the encription box ID —
U605 Setting the system (operational)
• Setting how to proceed if memory becomes full
during memory transmission —
• Setting an alarm for when reception is completed —
• Selecting if auto reduction in the auxiliary direction is to be performed —
• Setting the addition of an image to the report —
• Setting the error report display format —
• Setting the line-monitoring period —
• Setting the one-shot detection time for remote switching —
• Setting the continuous detection time for remote switching —
• Setting the initial condition of fax image scanning quality —
U606 Setting the system (operation unit and display)
• Setting the conditions under which an error indicator turns off —
• Setting the date format —
• Setting if the image scanning quality in fax mode is initialized —
• Setting if the scanning density in fax mode is initialized —
• Setting whether to skip unregistered abbreviated numbers
and one-touch key numbers on the list —
U607 Setting the system (communication 1)
• Setting the auto redialing interval —
• Setting the number of times of auto redialing —
• Setting the communication starting speed —
• Setting the reception speed —
• Setting the mode for remote switching —
• Setting the transmission intervals —
• Sets the loop current detection before dialing —
• Sets the DIS signal to 4 bytes —
U608 Setting transmission
• Setting the method to process errors —
• Setting the number of times of DIS signal reception —
• Setting the reference for RTN signal output —
• Setting the waiting period to prevent echo problem at the sender —
• Setting the waiting period to prevent echo problem at the receiver —
• Setting ECM transmission —
• Setting ECM reception —
• Setting the criteria for receiving a TCF signal 1 —
• Setting the frequency of the CED signal —
U609 Setting communication time
• Setting the T0 time-out time —
• Setting the T1 time-out time —
• Setting the T2 time-out time 69
• Setting the Ta time-out time 30
• Setting the Tb1 time-out time 20
• Setting the Tb2 time-out time 80
• Setting the Tc time-out time 60
• Setting the Td time-out time —
1-3-1 Maintenance mode
(1) Maintenance mode item list
Fax
To Next Page
Loading...
