3A8
1-3-3
Remove any found.
With 5 V DC present at CN16-6 on the copier main PCB, check if
CN16-7 on the main PCB remains low when the job separator
eject switch is turned on and off. If it does, replace the job
separator eject switch.
With 5 V DC present at CN16-6 on the copier main PCB, check if
CN16-7 on the main PCB remains high when the job separator
eject switch is turned on and off. If it does, replace the job
separator eject switch.
Check visually and replace the pulley if deformed.
(3) Paper misfeeds
Problem Causes/check procedures Corrective measures
(1)
Paper jams when the
main switch is turned
on.
(2)
Paper jams in the job
separator during
copying (jam in job
separator eject
section).
A piece of paper torn from
copy paper is caught
around the job separator
eject switch.
Defective job separator
eject switch.
Defective job separator
eject switch.
Check if the job eject pulley
or job eject roller is
deformed.
To Next Page
Loading...
