Copystar CS-2030 - Adjusting the Margins for Scanning the Original from the DF

3A7
1-4-13
(7) Adjusting the margins for scanning the original from the DF
Perform the following adjustment if margins are not correct.
U402 U404
U403
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
• 20 cpm copier
Change the setting.
• Increasing the value using the
cursor right key makes the
margin wider.
• Decreasing the value using the
cursor left key makes the
margin narrower.
Adjustment items
A MGN: DF left margin
B MGN: DF leading edge margin
C MGN: DF right margin
D MGN: DF trailing edge margin
Yes
No
Start
Enter maintenance mode.
Enter “404” using the numeric keys.
Press the start key.
Place an original on the DF
and make a test copy.
Press the start key.
The new setting is stored.
Setting range (default)
DF left margin: 0.0 to 10.0 (2)
DF leading edge margin: 0.0 to 10.0 (3)
DF right margin: 0.0 to 10.0 (2)
DF trailing edge margin: 0.0 to 10.0 (2)
Changing the value by 1 moves
the margin by 0.5 mm for all.
Are the margins correct?
Press the interrupt key.
Select the item to be adjusted
using the cursor up/down keys.
Yes
No
Proceed to another mode?
Press the stop/clear key.
Exit maintenance mode.
End
Figure 1-4-16
DF leading edge margin (3 ± 2.5 mm)
DF left margin
(2.5
+1.5
mm)
DF right margin
(2.5
+1.5
mm)
Ejection direction
(reference)
DF trailing edge margin
(3 ± 2.5 mm)
–2.0
–2.0