3B1
1-4-2
(2) Table of general classification
Error code Description
U00000 No response or busy after the set number of redials.
U00100 Transmission was interrupted by a press of the stop/clear key.
U00200 Reception was interrupted by a press of the stop/clear key.
U00300 Recording paper on the destination unit has run out during transmission.
U004XX A connection was made but interrupted during handshake with the receiver unit (refer to page 1-
4-4 "U004XX error code table").
U00500 Multiple communication was interrupted and call was not made on destination units after
interruption.
U006XX Communication was interrupted because of a machine problem (refer to page 1-4-4 "U006XX
error code table").
U00700 Communication was interrupted because of a problem in the destination unit.
U008XX A page transmission error occurred in G3 mode (refer to page 1-4-5 "U008XX error code table").
U009XX A page reception error occurred in G3 mode (refer to page 1-4-5 "U009XX error code table").
U010XX Transmission in G3 mode was interrupted by a signal error (refer to page 1-4-6 "U010XX error
code table").
U011XX Reception in G3 mode was interrupted by a signal error (refer to page 1-4-8 "U011XX error code
table").
U012XX Not used.
U013XX Not used.
U01400 An invalid one-touch key was specified during communication.
U01500 A communication error occurred when calling in V.8 mode.
U01600 A communication error occurred when called in V.8 mode.
U017XX A communication error occurred before starting T.30 protocol during transmission in V.34 mode
(refer to page 1-4-10 "U017XX error code table").
U018XX A communication error occurred before starting T.30 protocol during reception in V.34 mode
(refer to page 1-4-10 "U018XX error code table").
U02200 F-code based relay broadcast transmission failed because the data registered in the F-code
relay box was deleted.
U02400 An interoffice F-code based relay transmission was interrupted because of a mismatch in the
specified relay box number.
U03000 No document was present in the destination unit when polling reception started.
U03200 In interoffice F-code based bulletin board reception, data was not stored in the box specified by
the destination unit.
U03300 In polling reception from a unit of our make, operation was interrupted due to a mismatch in
permit ID or telephone number. Or, in interoffice F-code based bulletin board reception,
operation was interrupted due to a mismatch in permit ID or telephone number.
U03400 Polling reception was interrupted because of a mismatch in individual numbers (destination unit
is either of our make or by another manufacturer).
U03500 In interoffice F-code based bulletin board reception, the specified F-code confidential box
number was not registered in the destination unit.
U03600 An interoffice F-code based bulletin board reception was interrupted because of a mismatch in
the specified F-code confidential box number.
U03700 Interoffice F-code based bulletin board reception failed because the destination unit had no F-
code based bulletin board transmission capability, or data was not stored in any F-code
confidential box in the destination unit.
U04000 In interoffice F-code based transmission mode, the specified F-code box number was not
registered in the destination unit.
U04100 F-code based transmission failed because the destination unit had no F-code based reception
capability.
To Next Page
Loading...
