Copystar CS-2030 - Procedure for Assembly and Disassembly; Adjusting the Margin for Printing

3A6
1-4-2
1-4-2 Procedure for assembly and disassembly
(1) Adjusting the margin for printing
Perform the following adjustment if the printer leading edge margin for duplex copying (second face) is not correct.
Procedure
Yes
No
Start
Enter “402” using the numeric
keys.
Press the start key to
output a test pattern.
Change the value using the
cursor left/right keys.
Select “TRAIL 2” using the
cursor up/down keys.
Is the margin correct?
Enter maintenance mode.
Press the start key.
Press the interrupt key.
The new setting is stored.
Press the start key.
Press the stop/clear key.
Exit maintenance mode.
End
Setting range: –5.0 to +10.0
Reference: 4.5
Changing the value by 1 moves the margin by
0.5 mm.
Increasing the value makes the margin wider
and decreasing it makes the margin narrower.
Figure 1-4-1
Printer leading edge margin
for duplex copying
(second face, 3 ± 2.5 mm)