3A7
1-4-11
(6-2) Adjusting the DF trailing edge registration
Perform the following adjustment if the original scanning end position is not correct.
Caution:
If the copies look like copy example 2, clean the DF original scanning section.
Procedure
• 20 cpm copier
Enter maintenance mode.
Enter “071” using the numeric
keys and press the start key.
Yes
No
Start
End
• For copy example 1,
increase the value using
the cursor right key.
• For copy example 2,
decrease the value using
the cursor left key.
Press the interrupt key.
Exit maintenance mode.
Press the stop/clear key.
Place an original on the DF
and make a test copy.
Is the image correct?
Setting range: –32 to +32
Reference: 0
Changing the value by 1 moves
the copy image by 0.19 mm.
Increasing the value moves the trailing
edge of the copy image backward,
and decreasing it moves the trailing
edge of the image forward.
Press the start key.
The new setting is stored.
Select “TRAIL EDGE ADJ”
using the cursor up/down
keys.
Figure 1-4-14
Original Copy
example 1
Copy
example 2
To Next Page
Loading...
