Copystar CS-2030 - Switching the Paper Path in the Duplex Unit

3BN/3A4
2-1-9
(1) Switching the paper path in the duplex unit
In duplex mode, when the reverse face of the paper is copied, the paper is switched back in the feedshift section and
conveyed to the duplex unit. The paper is then conveyed to the paper conveying section of the copier by the upper and
lower duplex rollers.
When ejecting paper to the eject tray, the duplex feedshift solenoid (DUPFSSOL) turns on to operate the duplex feedshift
guide to switch the paper path to the eject tray.
Duplex feedshift guide
Eject tray
Figure 2-1-13