3B5
1-4-4
(4) Adjusting the pressure of curl eliminator mechanism
Increase the pressure of the curl eliminator mechanism to reduce upward curling of paper stacked on the intermediate tray
if a paper jam occurs when batch ejection is performed because of strong upward curling.
Procedure
1. Remove the paper conveying unit from the
copier.
2. Loosen the two screws from the front and
rear curl eliminator pressure adjusting plates
respectively and then remove the plates.
3. Refit the all removed parts.
Paper conveying unit
Curl eliminator pressure
adjusting plate
Curl eliminator pressure
adjusting plate
Figure 1-4-4
To Next Page
Loading...
