Copystar CS-3035 - Adjusting the Position of the Center Adjuster (Center Line Alignment)

5FF
1-4-4
(4) Adjusting the position of the center adjuster (center line alignment)
Perform the following adjustment if the center lines of the copy image and the copy paper are misaligned.
Procedure
Figure 1-4-5 Adjusting the position of the center adjuster
Is the center of the
image aligned with that of
the copy paper?
Run maintenance item U993.
Select “VTC PG1” and output a
test pattern.
Retighten two screws 1 and
insert the drawer.
Open the drawer.
Loosen two screws 1 holding the
center adjuster and change the
position of the center adjuster.
• For output example A, move
the adjuster in the direction of
the black arrow ( ).
• For output example B, move
the adjuster in the direction of
the white arrow ( ).
Loosen five screws 2 holding the
deck front cover and change the
position of the deck front cover so
that the level indicating the position
of the center adjuster and that of
the deck front cover are the same.
Exit maintenance mode.
Enter maintenance mode.
Yes
Start
End
No
Retighten five screws 2.
Level
indicators
Level
indicators
Level indicatorLevel indicator
Screws 2
Screw 1
Screw 1
Screw 2
Center
adjuster
Deck front cover
Figure 1-4-4
Output example A Output example B