Coretec BS Series - Page 57

BS Controller for AC SERVO PRESS
Instruction Manual Ver1.08
BS-M3A-1B
- 57 -
communication
error
stopped.
The omission of the communication cable or the
abnormalities of the master are suspected.
098
The abnormalities
in a battery
Backup battery voltage fell. A battery needs to be
exchanged.
Detailed alarm code
It is a detailed alarm code in the case of the abnormalities in a driver
Alarm
code
Name
Meaning/correspondence
102
FPGA error.
They are the abnormalities of a logic IC. Repair is
required.
103
Updating timing
violation of a basic
parameter.
A tool type setup was performed during servo-on.
Please do not perform a tool type setup during
program execution.
104
Origin isn’t
finished.
Positioning operation was performed for orogin not to
be performed. Please perform origin.
200
The abnormalities
in a motor type
Abnormalities were discovered by the contents of a
motor table. Please refer to the details of a motor
table.
202
Outside of the
range-rated
current.
Abnormalities were discovered by the contents of a
motor table. Please refer to the details of a motor
table.
203
Rated current is
outside of the
range.
Abnormalities were discovered by the contents of a
motor table. Please refer to the details of a motor
table.
204
Outside of the
range-max speed.
Abnormalities were discovered by the contents of a
motor table. Please refer to the details of a motor
table.
207
Outside of the
range-
max rated
current.
Abnormalities were discovered by the contents of a
motor table. Please refer to the details of
a motor
table.
211
Outside of the
range-encorder
direction.
Abnormalities were discovered by the contents of a
tool table. Please refer to the details of a tool table.
212
Outside of the
range-origin
direction.
Abnormalities were discovered by the contents of a
tool table. Please refer to the details of a tool table.
213
Outside of the
range-encorder
resolution.
Abnormalities were discovered by the contents of a
tool table. Please refer to the details of a tool table.
214
Outside of the
range-origin speed.
Abnormalities were discovered by the contents of a
tool table. Please refer to the details of a tool table.
215
Outside of the
range-creep speed.
Abnormalities were discovered by the contents of a
tool table. Please refer to the details of a tool table.
216
Outside of the
range-origin
sensor logic.
Abnormalities were discovered by the contents of a
tool table. Please refer to the details of a tool table.
217
Outside of the
Abnormalities were discovered by the contents of a