Corghi Artiglio Master Code - Page 105

Artiglio Master Code User Manual 105
UK
CODE POP-UP DESCRIPTION
E19
Horizontal axis cut-out switch or under power
E20
Perform machine calibration
E21
Repeat first calibration step
E22
Repeat second calibration step
E23
Motor protection during wheel clamping
E24
Motor protection during wheel release
E26
Horizontal translation motor overload cut-out switch
E27
P.: Missed encoder reading horizontal axis S.: Contact technical assistance
E32
P.: Micro tool rotation concurrently active S.:Contact technical assistance
E33
P.: Micro end stoke vertical axis concurrently active
S.:Contact technical assistance
E34
P.: Micro end stoke tool concurrently active S.: Restart machine
E35
Lifter not in working position
E36
P.: No wheel memorised S.: Perform scan
E38
P.: Reading failed S.: Repeat command
E39
P.: Missed encoder reading vertical axis S.: Contact technical assistance
E41
P.: Upper vertical micro-limit switch activated
S.: Contact technical assistance
E42
P.: Lower vertical micro-limit switch activated
S.: Contact technical assistance
E43
P.: Lift limit switch error S.: Contact technical assistance
E160
P.: Horizontal axis microswitch pressed S.: Release manually or de-icing
E161
P.: Upper bead breaker position not reached S.: Restart machine
E162
P.: Lower bead breaker position not reached S.: Restart machine
E163
P.: Tool rotation not complete S.: Contact technical assistance
E164
P.: Diameter not reached. S.: Contact technical assistance
E165
P.: Tool carriage height not reach S.: Contact technical assistance
E166
P.: Tool horizontal position not reach. S.: Contact technical assistance
E64
P.: P3K firmware missing or incorrect S.: Contact technical assistance