104 Artiglio Master Code User Manual
8. TROUBLESHOOTING
If the electricity supply fails with the MOUNT/DEMOUNT tool positioned between
the rim and the tyre, proceed as follows:
- Restart the machine without resetting it.
To horizontally move the wheel, keep the lifter joystick raised
and move
the joystick head
with single movements right or left. The actuator will
move by small amounts.
- Use the bead breakers, operating them up and down, to make enough room for
the MOUNT/DEMOUNT tool to be released from the tyre.
- If there is no power supply, the wheel can be
manually released by inserting an 8 mm diam-
eter steel pin in the hole and rotating anticlock-
wise (see Fig. 80)
ERRORS LIST
Fig. 80a shows an example of an error message.
CODE POP-UP DESCRIPTION
E1 Reset machine
E8
Vertical translation motor overload cut-out switch
E10
P.: Horizontal-axis encoder time-out S.: Restart machine
E11
P.: Vertical-axis encoder time-out S.: Restart machine
E12
P.: Incorrect horizontal axis motor rotation S.: Contact technical assistance
E13
P.: Tool microswitch rotation S.: Restart machine
80a
80
WARNING
To Next Page
Loading...
