Artiglio Master Code User Manual 37
UK
5.4. AUTOMATIC WORK PROCEDURE
During operating stages, some parts of the machine will move by
themselves.
To stop operations at any moment, press the STOP button.
WARNING
The automatic features can be accessed in one of two ways:
a) Press one of the buttons
(Fig. 30) to select the type
of tyre. This method should be followed each time a
new wheel or rim must be acquired.
b) Press the button
(Fig. 30) to recall the
last wheel or rim acquired, avoiding the acquisition
phase. In this case skip to paragraph (5.4.b).
The machine is capable of distinguishing a
rim with a tyre from one without a tyre and
indicating the operating sequence to follow.
While still remaining within the automatisms,
if necessary it is possible to carry out the in-
dividual phases manually or to use the arrows
to select the sequence to carry
out (Fig. 30a).
NOTICE
The machine carries out a check on the state of the sensors. If it finds faults it limits or
completely excludes automatic operations depending on how serious the fault is
NOTICE
TYPES OF TYRES:
NORMAL: commonly used tyres, not lowered and with medium rigidity sides, with not very high
mounting/demounting tension.
RFT-UHP: Runflat tyres with reinforced sides, self-supporting, high pressure or lowered, with
30
30a
To Next Page
Loading...
