38 Artiglio Master Code User Manual
high mounting/demounting tension.
SOFT: commonly used tyres with particularly soft sides (ex: Michelin Energy), with contained
mounting/demounting tension.
BALLOON: off-road tyres that are particularly voluminous and/or heavy or with significantly
sized sides, with high width/side ratio. These usually require a manual support provided by the
operator during the most critical handling phases.
Note: the mounting/demounting tension is also based on the rim/tyre combination, therefore we
defer to the experience of the tyre mechanic (operator) for adequate identification of the type
of automatism that should be used.
5.4.a ADVANCED AUTOMATIC FEATURES (7 sequences)
AUTOMATIC ACQUISITION OF WHEEL DATA
For an optimal reading of dimensions, the wheel must be beaded.
NOTICE
The top bead breaker automatically hooks during the descent phase.
PHASE 1: Press the icon (Fig. 30a) to edit
image and automatically acquire and store the size of
the wheel or of the rim only.
If, following automatic detection of the wheel/rim, the detected diameter needs to
be corrected, you must act on the buttons
and (Fig. 30a). To maintain the
correction in the next wheel recalls, the new diameter must be stored using the
button
(Fig. 30a). This command stores only the diameter variations and not
the tool position variations.
NOTICE
If the wheel dimensions are not identified (Fig. 30c), the operator may proceed as follows:
WARNING
30a
To Next Page
Loading...
