64 Artiglio Master Code User Manual
15- Operate the lever and move up the
lower bead breaker disc (Figs. 40n - 40o) to 5 mm
above the upper edge of the rim.
16- Press the Button for lower bead breaker
disc penetration and press the Pedal
to
rotate the turntable.
17- If necessary, operate the control to
slightly lift the lower bead breaker.
5.5.d. MOUNTING
Always check that the tyre/rim combination is correct in terms of compatibility
(tubeless tyre on tubeless rim; tube type tyre on tube type rim) and geometrical size
(keying diameter, cross-section width, off-set and shoulder profile) before mounting.
Also check that rims are not deformed, that their fixing holes have not become
oval, that they are not scaled or rusty and that they do not have sharp burrs on the
valve holes.
Check that the tyre is in good condition with no signs of damage.
WARNING
1- Thoroughly lubricate the sidewalls of the tyre
around the entire circumference of the lower and
upper bead (Fig. 41).
2- Operate the control
to remove the disc
from the work area.
3- The tool is already positioned at the correct
40n
40o
41
To Next Page
Loading...
