98 Artiglio Master Code User Manual
In some cases, the sensor conveys data only if tyre pressure changes by at least 0.2.
For these sensors, the message DEFLATE WHEEL will appear on the display, so a
pressure change is required to enable valve transmission.
NOTICE
If data is not acquired, the message “TPM SENSOR
DOES NOT TRANSMIT” (Fig. 77g) will appear on the
display. Check the correct position of the sensor and
repeat the procedure pressing the key
(1, Fig.
77g). If the problem persists, check sensor integrity.
If broken, replace following the instructions in the
section on sensor data (2, Fig. 77h).
-At the end of operations, press the key (1, Fig.
77h) to exit the programme and repeat the procedure
for a functional check.
Press the key
to exit TPMS and go back to the
main screen.
NOTE: At the next activation of the TPMS device the screen in Fig. 77f will be displayed
with the data of the previous vehicle. Press button 3, Fig. 77f to select a new vehicle or
button 1, Fig. 77f for a new sensor reading.
TROUBLESHOOTING
The TPMS does not respond
Sensor connector disconnected
- Connect the connector (see Fig. 77i)
The sensor assembled on the valve is broken
- Check TPMS operation with another sensor faulty TPMS
- If the problem persists, contact technical assistance.
6.6 LUBRICATORS
The lubricators deliver lubricating fluid between the
bead breaker disc and tyre bead. Correct use allows
the operator to facilitate bead removal from the rim,
in safe conditions, as he does not have to operate with
a brush near moving parts.
Intended operating conditions
The lubricator has been designed exclusively to lubri-
77i
1
78
2
1
77h
1
77g
To Next Page
Loading...
