Artiglio Master Code User Manual 95
UK
6.4 TEMPERATURE MEASURING SENSOR
From the main screen (Fig. 76) press the key .
The temperature measuring sensor is an electronic
device to read the tyre temperature. Correct use
allows the operator to check and display the tyre
bead and sidewall temperature, for mounting/
demounting as indicated by WDK regulations for
RUN FLAT and UHP tyres.
Intended operating conditions
The temperature measuring sensor has been
designed exclusively to measure tyre tempera-
ture, as described in this manual. Any other use
is inappropriate.
Technical specifications
Reading precision ………………………….0.1°C
Operation
- Press the key to enable the temperature
measuring sensor.
- Move the sensor so it is in contact with the bead
(Fig 76a, if the wheel is demounted) or sidewall
(Fig. 76b if mounted on the rim).
For correct, precise reading, place the two semi-rings against the tyre, making sure
there are no parts which come between the two semi-rings.
NOTICE
- The display instantly shows the temperature measured in °C and °F (see Fig. 76c).
- The background changes colour to immediately indicate the status of conformity to the
WDK procedure in relation to the temperature value measured:
Green the tyre is at the right temperature. Opera-
tions may be carried out conforming to the WDK
procedure. The temperature range is 20 - 25 °C
Yellow the tyre is at temperature limits. It is not
advisable to carry out operations according to the
WDK procedure. The temperature range is 15 - 19
°C and 26 - 30 °C
Red the tyre temperature is outside the tempera-
76a
76b
76c
76
To Next Page
Loading...
