34 Artiglio Master Code User Manual
5.2. PRELIMINARY CHECKS
Check that there is a pressure of at least 8 bar on
the Filter Regulator pressure gauge.
If the pressure is lower, the operation of some
automatic procedures is not guaranteed and the
display will show LOW-PRESSURE Fig. 25.
However, it is still possible to operate in manual
mode.
After the correct pressure has been restored, the
machine will function properly.
Check that the machine has been adequately connected to the power mains.
5.3. LOADING AND CLAMPING THE
WHEEL
- Load the wheel onto the wheel lifter (Fig. 26a).
- Operate the Lever and lift the wheel
until it is positioned on the turntable (see Figs. 26b,
26c, 26d) making sure the movable pin is inserted
in one of the fastening bolt holes (see Fig. 26e).
- fit the cone on the handle, using the extension
as necessary (see the diagram for using cen-
tring and clamping accessories per type of rim
in this manual).
- Insert the handle (a) in the central hole and turn
clockwise until it stops (Fig. 26f).
26b
26c
26d
26a
25
To Next Page
Loading...
