36 Artiglio Master Code User Manual
tion) standards.
The initials DOT certify that tyres comply with the safety
standards adopted by the United States and Canada
(these wheels cannot be sold on these markets).
High-performance wheels (asymmetric curvature) -
Fig. 29-b: Some European wheels have rims with a very
pronounced curvature C, except in the area of the valve
hole A where the curvature is less pronounced B. On
these wheels the bead must first be broken in the area
of the valve hole, on both the top and bottom sides.
Wheels with pressure sensor - Fig.29c. To operate cor-
rectly on these wheels and avoid damaging the sensor
(which is incorporated in the valve, fixed with the
belt, glued inside the tyre, etc.) appropriate mount-
ing/demounting procedures should be followed (ref.
Approved mounting/demounting procedure for runflat
and UHP tyres)
The TPMS device (optional accessory) can be used to check the proper operation
of pressure sensors.
NOTICE
5.3.a DEFLATING THE TIRE
Operate the valve to fully deflate the tyre (Fig. 29d).
A
B
C
29c
A
B
C
29b
29d
To Next Page
Loading...
