Corghi Artiglio Master Code - 5.5 Manual Work Procedure

Artiglio Master Code User Manual 61
UK
5.5. MANUAL WORK PROCEDURE
5.5.a. MANUAL CONFIGURATION OF WHEEL DATA
- From the main screen (Fig. 39) press the wheel
icon
to quickly select the rim Ø from a list
(see Fig. 39a)
Otherwise, from the main screen:
- Press the arrows to increase or de-
crease the rim Ø in inches, until the required value.
- Press the small arrows to increase or
decrease the rim Ø by tenths of an inch and make
micro-corrections.
5.5.b. BEAD BREAKING
See the section on “bead breaking” in the automatic
procedure.
5.5.c. DEMOUNTING
1- Press the button to orient the movable tool 1
as shown in Fig. 40.
39a
1
40
37l
37m
39