Corghi Artiglio Master Code - Tread Thickness Measuring Sensor

Artiglio Master Code User Manual 93
UK
6.3 TREAD THICKNESS MEASURING SENSOR
From the main screen (Fig. 75) press the key .
The tread thickness measuring sensor is an elec-
tronic device to read vehicle tyre tread thickness.
Correct use allows the operator to check and see
whether the tyre tread value shown conforms to
the highway code.
Intended operating conditions
The tread thickness measuring sensor has been designed exclusively to measure vehicle
tyre tread thickness, as described in this manual. Any other use is inappropriate.
Press key
to enable the tread thickness measuring sensor.
Sensor resetting:
When first used and whenever necessary, check sensor resetting.
NOTICE
Resetting procedure
1. Place the cylindrical cursor on a rigid surface
and press until it is fully inserted in the sensor
(see Fig. 75a).
When the flat part of the sensor is lying entirely
on the surface, zero conditions will be achieved.
2. Keep the sensor pressed down, and press the
key (see Fig. 75b).
A confirm message will appear. Enter OK.
3. The sensor is reset to zero.
Operation
- Rest the mobile part of the sensor (cylindrical
sensor) in the tyre furrow where the tread thickness
is to be measured. Press the sensor so that the
flat part adheres to the tread, making the sensor
return (see Fig. 75c).
75a
75b
75c
75