corob Tatocolor - Identifying Information and Reference Standards

2-GENERAL INFORMATION 2-5
COROB™ TATOCOLOR
Figure 2-1
The following warning label is applied on the front of the machine, near the dispensing nozzle area
(Figure 2-2):
5. Label “Risk of crushing” (only model TA)
Indicates the dangerous area during the following phases: punching and plastic plug insertion.
Figure 2-2
2.4 Identifying information and reference standards
COROB S.p.A. designs, manufactures, and subjects its machines to tests to ensure compliance
with safety and electromagnetic compatibility regulations. Any changes not authorized by COROB
S.p.A. may jeopardize this compliance.
The manufacturer certifies, under its own responsibility, that the machine to which this statement
refers to, complies with the essential requirements foreseen by the regulations:
 Machinery Directive 2006/42/EC
 Electromagnetic Compatibility Directive 2004/108/EC
The machine complies with all applicable standards.
The equipment complies with the Directive 2002/96/EC and 2003/108/EC on waste electrical and
electronic equipment (WEEE).
The machine has an identification plate on the rear door, indicating (Figure 2-3):
1. manufacturer's name
2. CE marking
3. WEEE marking
4. machine model
4
1
2
3