3-FEATURES 3-5
COROB™ TATOCOLOR
Figure 3-5
Figure 3-6
3.2.4 Humidifier cap
By their very nature, colorants tend to dry out; this tendency may be more or less strong
depending on the type of colorant and the environment conditions where the dispenser is
installed, such as the temperature, relative humidity, etc.
The machine is equipped with a humidifier cap to keep the dispensing nozzle center at a moisture
level to prevent the colorant from drying out; this device contains a moistened sponge.
The sponge is housed inside the cap, and must be cleaned and moistened periodically (chapter
8.4).
Sliding cap
(Figure 3-7)
This is a simple cap, which opens thanks to the push applied to the opening bar while the can is
being positioned; the cap closes when the can is removed. Dispensing is allowed only if the can is
present, that is to say when the cap is properly open.
Automatic sliding cap or sliding Autocap
(Figure 3-8)
This is an automatically activated cap (Autocap) which opens automatically when the can placed
on the shelf obscures the photocell, and closes automatically when the shelf is lowered and the
photocell disengaged or when the can is removed from the shelf.
2
3
1
To Next Page
Loading...
