4-SHIPPING, HANDLING AND UNPACKING 4-1
COROB™ TATOCOLOR
4 SHIPPING, HANDLING AND UNPACKING
4.1 General warnings
To avoid personal injuries and property damage, use the utmost care and caution when
handling the machine, and carefully follow the instructions given in this chapter.
The packing must be handled only by skilled personnel using appropriate handling
equipment. Never move the packing by hand or with inappropriate means, to avoid
personal injury or breaking the machine.
Make sure no one is in the vicinity during those unpacking operations that involve cutting
or removing binding systems using hazardous instruments.
4.2 Moving and handling the packed machine
The machine is carefully packed and prepared for shipping, firmly fastened to a sturdy wooden
base (pallet), covered externally with a wooden crate or cardboard box, and wrapped with bubble
plastic, cellophane, special corrosion-proof paper, etc., depending on the type and duration of
shipping planned for delivery.
The dimensions of the packing are the following:
Length
(mm)
Depth
(mm)
Height
(mm)
Weight of the packed
machine (kg)
Weight of the
packing (kg)
1050 770 1960
see technical
specifications
42
Use appropriate lifting equipment (lift truck with flat forks) to lift, handle and/or move the packed
machine, as follows.
Note the total weight of the packed machine as marked on the outer packing.
Position and space the lift forks to insert them into the pallet. Insert the forks into the slots
provided on the pallet, lift the packing, handle and move as needed, and carefully position it near
the installation site.
4.3 Environment conditions of the installation site
Environment requirements for the site where the machine is to be installed.
Clean and dust-free.
A level, stable floor.
Fitted with a grounded power supply socket.
Ventilated to prevent the concentration of harmful fumes.
Equipped with sufficient lighting. The machine workplace must be equipped with devices that
allow adequate artificial light, to protect the operator's health and safety. The room lighting
must therefore ensure good visibility from every point of the machine.
When using colorants containing volatile solvents the room in which the machine is
installed must be spacious, with good ventilation (air exchange) and no type of parts must
be leant against or stocked close to the machine.
The environment working conditions of the machine must meet the following requirements:
To Next Page
Loading...
