7-USING THE DISPENSER 7-1
COROB™ TATOCOLOR
7 USING THE DISPENSER
7.1 General warnings
The machine must be used by a single operator.
It is strictly forbidden to bypass or disable the safety devices and protections.
The rear door and panels must be kept closed at all times.
The substances that may be used on the machine--such as colorants, paints, solvents,
lubricants and cleansers--may be hazardous to your health; handle, store and dispose of
these substances in keeping with current regulations and the instructions provided with
the product.
The operator is guided in running the machine by the COROB™ management application program,
which displays the instructions to be carried out and the actions performed by the machine.
After selecting the appropriate options from the application program (selection of the product,
formula and cansize) proceed as described in the following chapters.
7.1.1 Warnings on the use of colorants
Before using any colorant, carefully read the SAFETY DATA SHEET that the dealer
or manufacturer of the product is required to provide, and observe all of the safety
instructions provided.
Below are some of the most common warnings and safety precautions provided by colorant
manufacturers.
Harmful if swallowed.
Avoid eye and skin contact. In case of eye and skin contact, rinse with plenty of water.
Keep out of the reach of children.
When compulsory, use personal protection equipment for eyes and hands.
In case of accidental product leaks or spills, thoroughly ventilate the area and clean immediately
with water.
Do not dispose of colorant in the sewage system. Follow local regulations when disposing of
waste.
7.2 Running COROB™ TATOCOLOR TB
After you have loaded the can and confirmed dispensing, keep hands away from the
dispensing area, until when the machine has finished dispensing.
7.2.1 Positioning/loading cans
The machine is accessorized with a manual shelf allowing the cans or bins to be aligned with the
dispensing nozzles.
The manual shelf is fixed to the machine and can be raised or lowered so as to place cans of
different sizes under the dispensing nozzles.