Curtis 1226 User Manual

3 — PROGRAMMABLE PARAMETERS
pg. 27
Return to TOC Curtis Model 1226 – September 2019
3 — PROGRAMMABLE PARAMETERS
The 1226 controller has numerous parameters that you can program using a Curtis handheld
programmer or Curtis PC Programming Station. Use these parameters to customize a vehicle’s
performance and functionality.
Note: For information on Curtis programming devices, see page 90.
e parameters are grouped hierarchically into menus and are described in the following topics.
You must cycle the keyswitch aer you change a parameter marked as [PCF]. If you do not cycle the
keyswitch, the controller generates a Parameter Change Fault. To clear a Parameter Change Fault,
cycle the keyswitch.
APPLICATION SETUP MENU
e Application Setup menu contains the following menus:
APPLICATION SETUP MENU
SPEED MODE MENU......................... p. 27
THROTTLE MENU............................... p. 33
INTERLOCK BRAKING MENU............. p. 36
MAIN RELAY MENU............................ p. 37
EM BRAKE MENU............................ p. 38
BATTERY MENU............................... p. 39
EMERGENCY REVERSE MENU............ p. 42
HORN MENU..................................... p. 44
DRIVERS MENU............................... p. 44
MISC MENU.................................... p. 46
Speed Mode Menu
e controller provides two speed modes. e modes are useful in cases where the vehicle will be
driven under dierent driving conditions. A typical usage is to congure one speed mode for outdoor
driving and the other speed mode for slower indoor driving.
The speed mode parameters let you configure speed-related functions such as minimum and
maximum speeds and acceleration and deceleration rates.
e following sections describe the submenus of the Speed Mode menu:
Mode 1 and Mode 2 Menus on page 28
Other Menu on page 29
Fine Tuning Menu on page 30

Curtis 1226 Specifications

General

Brand	Curtis
Model	1226
Category	Controller
Language	English