Curtis 1226 - Emergency Reverse Menu

3 — PROGRAMMABLE PARAMETERS
Curtis Model 1226 – September 2019
Return to TOC
pg. 42
BATTERY MENU — BDI SETUP MENU, cont’d
PARAMETER VALUES DEFAULT DESCRIPTION
BDI Reset Percent 0%-100% 75% Sets the percentage of battery voltage above which the BDI
percentage will not reset when the keyswitch is turned on.
When a battery has a high BDI percentage, its oat voltage when
the keyswitch is powered on could cause false BDI resets. The
BDI Reset Percent parameter lets you preempt this problem by
specifying a minimum threshold for resetting the BDI percentage.
Full Charge Voltage 0.90-3.00V 2.35V Sets the voltage above which the controller considers the battery
as nished charging.
Start Charge Voltage 0.90-3.00V 2.10V Sets the voltage at which the controller considers the battery as
starting to charge.
Charge Time 0-600 minutes 300 Species how many minutes it takes for the BDI percentage to
increase from 0% to 100% while the battery is being charged.
When a charger is plugged in, the battery voltage gradually
increases to the full level.
To accurately reect the state-of-charge, during charging the
BDI percentage increases by 1% when the specied number of
minutes elapses.
Note: Higher battery amp/hour ratings require a larger Charge
Time.
Lift Lockout Threshold 0-%50% 20% Sets the BDI percentage at or below which the controller
activates the hydraulic lift lockout function.
Note: When hydraulic lift lockout is active, the controller disables
the hydraulic lift to prevent battery damage.
Emergency Reverse Menu
You can congure many aspects of the emergency reverse feature, including the following:
• Whether emergency reverse is activated by a normally open switch, normally
closed switch, or both normally open and normally closed switches.
• Whether the operator can activate emergency reverse while driving in reverse.
• How long the vehicle will operate while an emergency reverse switch is active.
• e rate at which the vehicle decelerates to a stop.
• e rate at which the vehicle accelerates in the reverse direction.
• How the controller handles belly button wiring (BB Wiring) faults.
Use the parameters in the following table to congure the emergency reverse feature.