Curtis 1226 - MOTOR MENU

4 — MONITOR MENU
pg. 59
Return to TOC Curtis Model 1226 – September 2019
MOTOR MENU
e following table describes the elds on the Motor menu.
MONITOR MENU — MOTOR MENU
FIELD VALUES DESCRIPTION
Motor Temperature –40 – 250°C Indicates the temperature read by the temperature sensor.
Motor Speed Percentage 0%-100% Indicates the motor speed. 100% represents the motor speed when the
voltage drop on the motor armature is greater than or equal to the Speed
Scaler parameter’s voltage.
Motor RPM –6000 – 6000 RPM Indicates the motor speed detected by the speed sensor.
Motor Resistance Used 0-32767mΩ Indicates the motor resistance used by the controller.
When the Motor Resistance Measured value changes, the controller
gradually updates the Motor Resistance Used value.
Motor Resistance Measured 0-32767mΩ Indicates the motor resistance detected by the controller.
This value will differ from the Motor Resistance Used value when the
Resistance Auto Comp parameter is on. See page 52.
Max Speed Limit On/Off Indicates whether the vehicle’s speed exceeds the speed limit specied
with the Max Speed parameter (page 53):
On = The vehicle is exceeding the speed limit.
Off = The vehicle is at or below the speed limit.