APPENDIX C — CURTIS PROGRAMMING DEVICES
Curtis Model 1226 – September 2019
Return to TOC
pg. 90
APPENDIX C — CURTIS PROGRAMMING DEVICES
Curtis programmers provide programming, diagnostic, and test capabilities for Curtis controllers. e power
for operating the programmer is supplied by the host controller via a 4-pin connector. When the programmer
powers up, it gathers information from the controller.
Two types of programming devices are available: the 1314 PC Programming Station and the 1313 handheld
programmer. e Programming Station has the advantage of a large, easily read screen. On the other hand,
the handheld programmer, with its 45×60 mm screen, has the advantage of being more portable and hence
convenient for adjusting in the eld.
Both programmers are available in User, Service, Dealer, and OEM versions. Each programmer can perform
the actions available at its own level and the levels below that—a User-access programmer can operate at only
the User level, whereas an OEM programmer has full access.
PC PROGRAMMING STATION (1314)
e Programming Station is an MS-Windows 32-bit application that runs on a standard Windows PC.
Instructions for using the Programming Station are included with the soware.
HANDHELD PROGRAMMER (1313)
The 1313 handheld programmer is functionally equivalent to the PC Programming Station; operating
instructions are provided in the 1313 manual. is programmer replaces the 1311, an earlier model with
fewer functions.
PROGRAMMER FUNCTIONS
Programmer functions include:
• Parameter adjustment — provides access to the individual programmable parameters.
• Monitoring — presents real-time values during vehicle operation; these include all inputs and outputs.
• Diagnostics and troubleshooting — presents diagnostic information, and also a means to clear the
fault history file.
• Programming — allows you to save/restore custom parameter settings les and also to update the
system soware.
To Next Page
Loading...
Need help?
General
