Cyclades alterpath pm8 - Page 11

Procedures
T
To Mount the AlterPath PM8i, PM10, or PM10i ......................................29
T
To Daisy Chain a PM................................................................................. 31
T
To Plug Devices Into AlterPath PM Outlets.............................................. 32
T
To Power On the AlterPath PM................................................................. 32
T
To Access the Console............................................................................... 34
T
To Log Into the AlterPath PM Through the Console (In Port)..................35
T
To Change the Default Password............................................................... 39
T
To Create Users Using the adduser Command.......................................... 39
T
To Assign Outlets to Users Using the assign Command ........................... 40
T
To Name the Outlets Using the name Command ...................................... 40
T
To Save the Configuration Using the save Command............................... 40
T
To Reset the Admin Password Using the Loopback Connector................41
T
To Upgrade PM Firmware......................................................................... 43