Chapter 3
Configuration
The AlterPath PM can be configured by any one of three methods:
• Command Prompt
• Browser – Available only when used in an integrated configuration.
• Text-based menu – Available only when used in an integrated
configuration, this menu allows you to invoke the various PM operations
such as cycling, switching on/off, and more.
The following sections offer basic instructions for configuring, restoring the
admin password, and uploading firmware on the AlterPath PM for either the
standalone or the daisy-chained configuration.
For information about integrated use with the AlterPath ACS, Cyclades-TS,
AlterPath KVM family of products, or the AlterPath Onsite, refer to the
AlterPath ACS User Guide, the Cyclades-TS User Guide, the AlterPath KVM/
net Plus Installation, Configuration, and User’s Guide, or the AlterPath
OnSite Installation, Administration, and User’s Guide respectively.
To Next Page
Loading...