Cyclades alterpath pm8 - To Log into the Alterpath PM through the Console (in Port)

Installation 35
Making a Direct Connection for Console Access
T To Log Into the AlterPath PM Through the
Console (In Port)
1. From your terminal emulation application, log into the console port as
“admin”.
As shown in the previous screen, the default password is “pm8.” If the
password has been changed from the default, use the new password.
2. If this is a first-time installation, see “Initial Configuration Using the
Command Prompt” on page 38 for instructions on changing the default
password, adding users, and assigning outlets to users.
3. See “Command Line Interface” on page 49, for procedures on logging in
and using the console commands to manage power on connected devices.
AlterPath PM
Copyright (c) 2002-2005
Cyclades Corporation
V 1.7.1 Oct 4, 2005
[PM]: IPDU: 1
[PM]: OUT: 8
Username: