Command Line Interface 75
Commands
save
Saves the current configuration in the flash device built in to all AlterPath PM
units. This command saves the username/password database and the specific
information pertaining to each outlet such as outlet name, outlet assignments,
outlet state.
If you save your configuration to flash it will be restored after the next reboot.
If you do not save your configuration to flash you will lose it all after the next
reboot.
Syntax
save
Arguments
N/A
Examples
To save the configuration to flash, type:
An error message will be displayed if there is an error while writing the
configuration to flash.
pm>save
Saving configuration to flash on IPDU #1 ... Done.
Saving configuration to flash on IPDU #2 ... Done.
To Next Page
Loading...