Commands
58 AlterPath PM Installation, Administration, and User’s Guide
To enable current protection status for all units, type:
To disable current protection status for all units, type:
cycle
Power cycles an outlet or groups of outlets. You can use the outlet number or
the outlet name (see command name for details).
Syntax
cycle all|<outlet number>
Arguments
all Turns off all outlets
<outlet number> Outlet number, such as “5”, outlet name such as
“sunfire”, or group of outlets such as “1, 3-5”
Examples
To cycle one outlet, type:
pm>currentprotection ON
IPDU #1: Overcurrent protection turned ON.
IPDU #2: Overcurrent protection turned ON.
pm>currentprotection off
IPDU #1: Overcurrent protection turned OFF.
IPDU #2: Overcurrent protection turned OFF.
pm> cycle 3
3: Outlet turned off.
3: Outlet turned on.
To Next Page
Loading...