Command Line Interface 61
Commands
factory_defaults
Resets the unit to its factory configuration so that all outlets are on, unlocked,
unnamed, and no users are created. When used with a daisy chain, this
command resets all units in the chain.
Syntax
factory_defaults
Arguments
N/A
Examples
To reset the factory defaults, type:
pm>factory_defaults
Setting configuration to defaults on IPDU
#1
1: Outlet turned on.
2: Outlet turned on.
3: Outlet turned on.
4: Outlet turned on.
5: Outlet turned on.
6: Outlet turned on.
7: Outlet turned on.
8: Outlet turned on.
Saving configuration to flash on IPDU #1
... done.
To Next Page
Loading...