120D-Link DSL-2750B Wireless N300 ADSL2+ Modem Router User Manual
Appendix D - Regulatory Information
your body before you touch any of the electronic components, such as the microprocessor. You can do so by periodically
touching an unpainted metal surface on the chassis.
You can also take the following steps to help prevent damage from electrostatic discharge (ESD):
1. When unpacking a static-sensitive component from its shipping carton, do not remove the component from the antistatic
packing material until you are ready to install the component in your system. Just before unwrapping the antistatic packaging,
be sure to discharge static electricity from your body.
2. When transporting a sensitive component, rst place it in an antistatic container or packaging.
3. Handle all sensitive components in a static-safe area. If possible, use antistatic oor pads, workbench pads, and an antistatic
grounding strap.
ErP Power Usage
This device is an Energy Related Product (ErP) that automatically switches to a power-saving Network Standby mode within
1minute of no packets being transmitted. It can also be turned o through a power switch to save energy when it is not needed.
Network Standby: 4.58 watts
Switched O: 0.23 watts
To Next Page
Loading...
Need help?
General
