● If the brake bleeder is not used, do the following,
● First, fill the brake fluid up to the upper limit line.
● Connect the hose to the bleeder valve to receive brake
fluid.
① Squeeze the brake lever completely loosen the
bleeder valve 1/2 turn, and tighten it again.
NOTE
·Do not release the brake lever unitl the bleeder valve
is tightened.
② Release the brake lever slowly to its fullest extent,
and leave it unattended for a few seconds.
③ Repeat the process specified in item ① and ②
until there is no more air bubbles coming out of the
bleeder valve.
● Check the fluid level often, and add fluid if the fluid
level is near the lower level.
● If no air leaks out of the bleeder hose, operate the brake
lever to check the presence of air.
● Assemble the bleeder valve.
TORQUE : 0.6kgf
·
m
● Add brake fluid up to upper level. Install diaphragm
and mater cylinder cap.
TORQUE VALUE : 1.0kgf
·
m
BRAKE PAD
REPLACEMENT
NOTE
·When replacing brake pads, replace whole set.
·Do not remove the brake hose when replacing brake
pads.
● Loosen the hanger pin.
To Next Page
Loading...
