INLET PIPE•REED VALVE
REMOVAL/INSTALLATION
● Remove the luggage box. (⇨3-3)
● Remove the air cleaner. (⇨5-4)
● Remove the carburetor. (⇨5-4)
● Remove the negative pressure tube connected to the
inlet pipe.
● Remove the oil pump cable. (⇨4-3)
● Remove the rear wheel mud guard. (⇨3-8)
● Remove the inlet pipe securing 4 flange bolts
connected to the L crank case.
● Remove the oil pump anchor plate.
● Remove the inlet pipe.
● Remove the reed valve.
● Install in the reverse order of removal.
NOTE
•Do not remove the reed valve and replace the
assembly if necessary.
•Keep the foreign material from entering into the
engine by cleaning around the needle valve.
INSPECTION
● Check the reed valve for fatigue or damage and replace
the reed valve assembly if necessary.
● Check the reed valve seat for cracks, damage and
clearance from the reed and replace the reed valve
assembly if necessary.
NOTE
•Be sure to replace the reed valve as an assembly.
Disassembling or bending the reed stopper will cause
engine trouble.
To Next Page
Loading...
