©
200706 6-1
Direct Testing
DAVIE XDc II
6 DIRECT TESTING
6.1 Overview
This functionality is primarily used to interrogate and erase ECU fault memory
and utilize various in- and outputs, dependant on the relevant test procedures
selected. The function "Direct Testing" must also be used for programming and
calibrating.
The knowledge and experience of the user is fully utilized, enabling the "Direct
Testing" to provide a "short cut" to the suspected fault. This functionality
supplements the "Guided Diagnostics" facility, ensuring the most efficient route
to the fault remedy.
The results of the diagnostic session and manually saved information will be
stored in a log file, which can be read out in the Administrator menu.
Figure 6-1 Start screen: User Login
To enter the Direct Testing mode, press the "Direct Testing" button on the
"Start" screen.
To Next Page
Loading...
Need help?
General