©
200706 9-5
VCI Configuration Manager
DAVIE XDc II
To check this setting, use the following instructions:
- Press with the <right touchpad key> on the Wireless Zero Configuration tray
icon.
- Select <Use Windows to manage WI-Fi>
- Then click "Start", click "Control Panel", click "Network and Internet
Connections", and then right click "Wireless Network connection", click
"Properties" and chose "Wireless Networks".
- The checkbox must be selected.
NOTE
The firmware version may only differ from the DAVIE XDc II and VCI right after
a VCI software update on the DAVIE XDc II. The firmware on the VCI will be
updated when the DAVIE XDc II application is started next time. This update
takes approximately one minute time.
9.2.2 Basic Setup
This screen is normally used to select a Wireless network adapter or to change
the VCI-ID Network Name (SSID).
If more than one VCI is used in the same workshop, the Basic Setup can be
used to easily setup a unique VCI-ID Network Name (SSID).
First connect the USB cable between the VCI and the DAVIE XDc II and
connect the VCI with the Vehicle Diagnostic Cable to the vehicle before
selecting the "Basic Setup" screen.
Figure 9-6 Basic Setup screen
To Next Page
Loading...
Need help?
General