Local Basic Operation 92
Figure 4-23
2) Tap on the top right corner.
The interface requiring device initialization is displayed. A pop-up message
reminding you to make sure the Device is initialized is displayed.
3) Tap OK.
 If the Device has not been initialized, Tap Device Initialization to perform
initializing by following the onscreen instructions.
 If the Device has been initialized, you can start adding it directly.
4) Tap Add Device.
The Add Device interface is displayed. See Figure 4-24.
You can add wireless device or wired device. The Manual takes adding wired
device as an example.
Figure 4-24
To Next Page
Loading...
Need help?
General
