Dalsa X64 Xcelera-CL PX4 - Page 66

64 • X64 Xcelera-CL PX4 Reference X64 Xcelera-CL PX4 User's Manual
step = 1
CORACQ_PRM_SHAFT_ENCODER_MULTIPLY min = 1
max = 32
step = (2**N)
CORACQ_PRM_PLANAR_INPUT_SOURCES Not available
CORACQ_PRM_CAM_TRIGGER_DELAY min = 0
max = 255
step = 1
CORACQ_PRM_EXT_TRIGGER_DELAY_TIME_BASE CORACQ_VAL_TIME_BASE_LINE (0x4)
CORACQ_PRM_BAYER_DECODER_ENABLE Not available
CORACQ_PRM_BAYER_DECODER_METHOD Not available
CORACQ_PRM_BAYER_DECODER_WB_GAIN_RED min = 0
max = 0
step = 1
CORACQ_PRM_BAYER_DECODER_WB_GAIN_GREEN min = 0
max = 0
step = 1
CORACQ_PRM_BAYER_DECODER_WB_GAIN_BLUE min = 0
max = 0
step = 1
CORACQ_PRM_BAYER_DECODER_WB_OFFSET_RED min = 0
max = 0
step = 1
CORACQ_PRM_BAYER_DECODER_WB_OFFSET_GREEN min = 0
max = 0
step = 1
CORACQ_PRM_BAYER_DECODER_WB_OFFSET_BLUE min = 0
max = 0
step = 1
CORACQ_PRM_CAM_CONTROL_PULSE0_HD_ALIGN Not available
CORACQ_PRM_CAM_CONTROL_PULSE1_HD_ALIGN Not available
CORACQ_PRM_EXT_TRIGGER_IGNORE_DELAY min = 0
max = 65535000
step = 1
CORACQ_PRM_CONTROL_SIGNAL_OUTPUT1 Not available
CORACQ_PRM_CONTROL_SIGNAL_OUTPUT2 Not available
CORACQ_PRM_EXT_TRIGGER_SOURCE_STR [0] = Automatic
[1] = From Trigg in #1
[2] = From Trigg in #2
[3] = From Board Sync
[4] = To Board Sync
[5] = From GIO
CORACQ_PRM_EXT_LINE_TRIGGER_SOURCE_STR [0] = Automatic
[1] = From Shaft Encoder Phase A
[2] = From Shaft Encoder Phase B
[3] = From Shaft Encoder Phase A & B
[4] = From Board Sync
[5] = To Board Sync
[6] = Pulse to Board Sync
[7] = To Board Sync When Grabbing
CORACQ_PRM_VERTICAL_TIMEOUT_DELAY min = 0
max = 16383000
step = 1
CORACQ_PRM_BAYER_DECODER_SATURATION_FACTOR min = 0
max = 0