DANIEL 2500 - Automatic Reports

MODELMODEL 2500_______________________________________________________2500_______________________________________________________
AUTOMATIC REPORTS
Automatic reports are initiated by report command statements in the configuration
program. The report command statements are used in either of two ways. They
are:
- Part of a program that performs a specific function associated with the
MODEL 2500 application configuration
- Independent statement that initiates a report printout when a specific
condition is met
An example of the first type of automatic report would be a report added to a
calculation program so the report will be printed each time the calculation is made.
An example of the second type of automatic report would be a report printed at a
specified time each day.
Program command statements are explained in detail in the CONFIG25 USER
MANUAL.
________________________________________________________________________________________________________________________________________
SECTIONSECTION 77
121