MODELMODEL 2500_______________________________________________________2500_______________________________________________________
Open Boolean variable that opens the valve when set
Close Boolean variable that closes the valve when set
MODBUS MASTER
The MODBUS MASTER sub-menu, which is the ninth sub-menu on the MAIN
MENU, has a lower level sub-menu for defining two remote units. The remote unit
definition sub-menu provides for identifying or changing the remote name ID, the
communications address and state variable, and the control option for each of the
two remote units.
Name Identifies the remote unit
Communications
Address Integer variable for the communications address of the
slave unit. If a communications address is not entered,
the default variable is zero. When the communications
address is zero, communications with the remote unit is
disabled.
State Integer variable that contains the current MODBUS
function code transmitted and received for the remote
unit. The state entry provides a means of monitoring the
activity between the master and remote units. Error
conditions are also visible by means of this variable.
Control Three options available here are:
IDLE Indicating no communications in progress
ACTIVE Indicating communications in progress
FAULT Indicating failure to communicate with a
slave unit
________________________________________________________________________________________________________________________________________
SECTIONSECTION 44
51
To Next Page
Loading...
Need help?
General