MODELMODEL 2500_______________________________________________________2500_______________________________________________________
_________________________________________________________
NOTE! Applications in which report lengths are in excess of
one page require a printer with an 8k buffer capacity,
or the baud rate of the printer output signal must be
lowered to 300, and the RPTGAP lower level sub-menu
must be set to SPACES.
_________________________________________________________
TABLES
The TABLES sub-menu, which is the seventh sub-menu on the MAIN MENU, has
a lower level sub-menu for each data table defined in the configuration.
TUBE SWITCHING
The TUBE SWITCHING sub-menu, which is the eighth sub-menu on the MAIN
MENU, provides the following list of variables that define common switching
parameters for all tube sets and individual switching parameters for each tube in
a set.
Common switching parameters for all tube sets:
Time delay variable The time delay variable is a user-entered interval
that allows time for a valve to change position, and
for the position change to affect the differential
pressure across the tube set before the position of
the next valve in the set is changed. The default
value for this variable is 120 seconds.
Verify DP variable The verify DP variable enables or disables
automatic verification of the differential pressure
________________________________________________________________________________________________________________________________________
SECTIONSECTION 44
49
To Next Page
Loading...
Need help?
General