____________________________________________________________________________________________________________ MODELMODEL 25002500
DATA ENTRY AT INITIAL STARTUP
Before a DANIEL INDUSTRIES MODEL 2500 INSTRUMENTATION SYSTEM
is placed in service, constants and variables for the application must be entered in
the microcomputer memory, or changed if this data differs from factory-installed
values. Data entry is made through the MODEL 2500 front panel keypad.
The following occurs when a MODEL 2500 system is configured for a specific
application:
- Default value for each constant and variable required for that
configuration is stored in the computer memory.
- Variables are stored in either a fixed or a dynamic mode, depending
on how the values are specified when the Model 2500 is initially
configured with CONFIG25.
- Variables will remain as configured until modified.
- All variables and constants are named and are available for display in
real time on the front panel.
- Calculation variables are displayed only if units for the variables are
assigned.
- Calculation variables can be changed manually only if units for the
variables were assigned the first time the variables were defined.
________________________________________________________________________________________________________________________________________
SECTIONSECTION 33
36
To Next Page
Loading...
Need help?
General